Shushan Qixia

Full Version: Trouble Shooting Residential Tanning Beds
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
A residential tanning bed is typically purchased by men and women who want to have a tan without bothering to dress up and go to a tanning salon. A tanning bed at residence tends to make it more convenient for a person to get that superb tan. But a residential tanning bed also means further responsibility for the owner. Technology is in no way ideal, like the humans who use them. Identify extra info on clicky by browsing our novel website. Therefore, the home tanning bed may possibly be topic to many difficulties. Thankfully, the owner of such tanning bed need not get in touch with a technician each time something goes wrong with it. Right here is a guide that will be valuable for the owner of a residential tanning bed.

If the bed refuses to start off or to turn on, there could be four possible causes:

1. There is no energy supplied to the bed

2. There is a poor relay

three. There is a loose at the relay

four. There is a loose wire at the dial timer

The owner should inspect the plug and the breaker to make confident that there is power going to the bed. If the relay is bad, then there is no other way to repair the bed but to replace the relay. Myths And Have A Safe Tan | Charl83pale23 includes supplementary info about the inner workings of this viewpoint. As for loose wires, all the owner has to do is to tighten the loose connection.

If the lamps dont light up, there are five achievable causes:

1. Malfunctioning lamps

two. Malfunctioning ballast

three. Malfunctioning lamp holder

4. Malfunctioning starter

five. A loose wire at the ballast, or at the lamp holder or at the terminal

For any malfunctioning portion of the tanning bed, the owner will need to have to replace it. The owner ought to not attempt to fix it by himself. If you believe anything at all, you will possibly fancy to check up about Protected Approaches To Remain Tan Year-Round: Leading ten Factors To Use Sunless Tan. For the loose wire, the owner may just tighten the loose connection.

If the bench lamps will not light up, the cause could be any of these:

1. The bench is not plugged into the canopy

2. A loose wire in the connector in between the bench and the canopy

three. The wire in the bench-to-canopy connector could be burnt

The owner need to check if the bench is securely plugged into the canopy. If not, he need to right the situation. The loose wire necessary only a tightening. But if the wire is burnt, the owner have to retrieve some electrical tools so that he can strip the wire and replace the connector.

If the lamps do not operate nicely but the fans are operating fine, there are only two items to check:

1. The relay

two. The wire either at the terminal block or the relay

The owner must verify whether the relay is malfunctioning or not. If it is not functioning properly, this relay should be replaced. I discovered Protected Methods To Keep Tan Year-Round: Leading by browsing Yahoo. Any loose wire at the terminal block or at the relay can be corrected by tightening the connection.

For other tanning bed troubles, it is ideal that the owner consults the technician of the tanning bed supplier..